Warmlyyours Environ Flex Roll System For laminate/floating woo Manual do Utilizador descarregar pdf (Página 6)

Testing

Each Environ™ Flex Roll is carefully tested before it is shipped from the

factory, and is packed to avoid damage during transit. However, damage does

sometimes occur in storage or transit, and sometimes during installation. We

strongly recommend you test the rolls:

• After unpacking the rolls but before you install them.

• After you have installed them but before you install the oor covering (i.e. while

the rolls are still exposed)

• After installation of the oor covering but before the thermostats are connected.

A simple test is a visual inspection to make sure there is no visible damage to

the heating element, and in particular to the cable component in the heater. We

recommend conducting an electrical test with an ohm meter to ensure that the

ohms resistance is what it should be. Ohms resistance can vary signicantly

depending on the ambient temperature and an allowance of -5% to +10% from

the nominal value at 68ºF (20ºC) is acceptable.

Pre-Installation Instructions

Ensure the suboor is structurally sound, and is clean and dry.

It shall be noted that most wooden suboor manufacturers (and also the wood

oor manufacturers) restrict the level of moisture content as well as Relative

Humidity for installing and maintaining sturdy suboors. Strictly follow the wooden

oor/suboor manufacturer guidelines for proper installation and maintenance of

wooden suboors in order to avoid any horizontal or vertical movement of the

suboor and consequential damage to your Environ™ Flex oor heating system.

To prevent damage to the rolls, special attention should be given to ensure that

no nails, screws, staple, or tacks are protruding from the sub oor before the

underlayment is installed. Take extra caution, if you use an automatic staple gun

to secure the cushion/underlayment to the suboor, a badly installed staple could

protrude from the oor and pierce and damage the Environ™ Flex Rolls.

Nails, screws, or staples should not be installed close to the rolls and power

supply cables. Permanent xtures, including built-in furniture, must NEVER be

installed on top of the rolls.

It is important to keep an accurate record of where the rolls are installed, to assist

you (and a future owner) to easily locate them; we suggest that you capture a

few photographs during the installation process, and ALWAYS save your custom

installation SmartPlan™.

Core to Core

Core to Sheath

Yellow

or Red

Ground

Yellow

or Red

Black

Core

Ground

Core

Yellow

or Red

Ground

Yellow

or Red

Black

Core

Ground

Core

Yellow

or Red

Ground

Yellow

or Red

Black

Core

Ground

Core

Core to Sheath

OHM Testing

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentários a estes Manuais

Sem comentários

Warmlyyours Environ Flex Roll System For laminate/floating woo Manual do Utilizador Página 6

Comentários a estes Manuais

Manuais e produtos relacionados com Para a casa Warmlyyours Environ Flex Roll System For laminate/floating woo